April 20, 2019

Logan lathe drive pulley bushings

Logan lathe drive pulley PT3, drive box cone pulley repair. Making the bushings for the Logan lathe 920 motor drive box. Due to excessive run out in the cone pulley. The inside diameter of the pulley was bored to accept a bushing that will reduce the size to that of the driven shaft, .75 inches. The outer diameter will be turned to 1.1255 to be a press fit with the pulley and cross drilled for clearance of the locking set screws. This video shows the machining operations of making the bushings, and is the final video on the repair of the Logan lathe drive box cone pulley repair series. Logan Lathe youtube = SHARE ROCKNTV1